Module BMW Fxx/Gxx Bosch MG1/MD1 ENET

350.00

Categories: , Tag:

Description

FID: 160, 161Bosch MG1/MD1

Module for reflashing through OBD2 connector by Ethernet for Bosch MG1 and MD1 ECUs used in BMW Fxx and Gxx vehicles.

Supports Bosch ECUs based on MCU NXP MPC5777 with 7.5Mb of main flash memory and Infineon Aurix TC298 with 8Mb memeory.

BMW Fxx/Gxx Bosch MG1 MPC5777 ENET (FID: 160)

BMW Fxx/Gxx Bosch MD1 MPC5777 ENET (FID: 161)

BMW Fxx/Gxx Bosch MG1 TC298 ENET (FID: 162) [TEST]

Module allows:

  • Software identification
  • Virtual reading from server (disabled while module is in TEST)
  • Reading if file not found in server
  • Writing with checksumm and CVN correction
  • DTC read and clear

Attention! 
Warning about new SW updates for BMW Fxx/Gxx

WARNING. Due to release of new software updates for BMW Vehicles, following versions of databases: ISTA-P 3.67.0.000 [2019] and ISTA-P 3.66.2.002 [2019] now are not supported for writing with BitBox, especially for module Bosch Fxx/Gxx MG1/MD1 E-NET. If file was not found on our server and vehicle is fresh, do not try to write file to ECU! And, even, if you have already tried, immediately, use RECOVERY option, without switching ignition OFF. Also you can try to use E-Sys or dealer flash tool ISTA-P for recovery!

The ISTA-P 3.67 version is particularly dangerous, as it can brick the ECU, sometimes without possibility of recovery, even with BENCH-MODE tools.

We are working on adding detection of new security system and disallowing of writing these files, while we had not develop writing of modified file.

Be careful!